panorama software,virtual tour software
Alternate Text
Joined: 2005-11-09
Send Msg:
Posts: 7
2005-11-28
#1

MrotatorC

Hello Guys, I was trying to stitch the examples agnos has on their website using the MrotatorC with the Sigma 8mm and could not get results with PTGui.  I applied the Batch template but got a mess when stitched and no good control points.  Anybody using this method, I am curious as to the quality of this type of method.

Thanks


Alternate Text
Forum Moderator
Joined: 2002-11-23
Send Msg:
Posts: 5438
2005-11-28
#2

I have an Agnos MrotatorC and it works perfectly with PTGui. It will not work with Panoweaver. The template offered works fine for me also, though you must set the control points. Using the latest version of PTGui 5.5 should see you right.

As this has nothing to do with this forum or any Easypano product this is not really the place to ask further questions about this set up.

Regards, Smooth


Alternate Text
Joined: 2005-11-09
Send Msg:
Posts: 7
2005-11-28
#3

Thanks smooth, yes the next question was going to be does it work with panoweaver and you answered that for me already.


Alternate Text
Joined: 2005-09-16
Send Msg:
Posts: 156
2005-11-29
#4
http://groups.yahoo.com/group/PanoTools/
and
http://www.panoguide.com/forums

would probably be good places to ask for advice.
Alternate Text
Joined: 2002-05-18
Send Msg:
Posts: 157
2005-11-29
#5
The page you are looking for is here, updated for PTGui. You screwed something up, it's impossible to get bad results with PTGui 5.5, look at this tutorial:
http://www.dffe.at