panorama software,virtual tour software
Alternate Text
Joined: 2009-08-30
Send Msg:
Posts: 64
2009-09-24
#1

Adapter Question

Finally, I am about to get the LA-DC58k Canon Adapter, Next week

Smooth:

1.-  Do you think I do not need anything else to fit the Raynox DCR on my G10 (Just in case, I also got a Raynox IE625 spacer ring)

2.-  And then to mount it on the NN180 I got the T-Adapter 20 mm offset.

3.- Also I got the tripod

That all, Is this ok........

 


Regards, Sal
Alternate Text
Forum Moderator
Joined: 2002-11-23
Send Msg:
Posts: 5438
2009-09-25
#2
Sounds right!

I have never used or seen this set up, so you will be the expert once you have it assembled.

Regards, Smooth
Alternate Text
Joined: 2009-08-30
Send Msg:
Posts: 64
2009-09-25
#3

ok thank you smooth


Regards, Sal
Alternate Text
Joined: 2009-08-30
Send Msg:
Posts: 64
2009-09-26
#4

Hello Smooth:

Do you know to install the NN180 & T-adapter to the Velbon Sherpa 600R


Regards, Sal
Alternate Text
Forum Moderator
Joined: 2002-11-23
Send Msg:
Posts: 5438
2009-09-26
#5
Remove the 3 way pan head by unscrewing in an anti-clockwise direction. Fit the 1/4"-3/8th" thread adapter to the Nodal Ninja 180 centre hole and screw the NN180 onto the Velbon tripod in a clockwise direction.

The NN T20 adapter screws to the bottom of the camera with the centerline to be aligned with the dead centre of the lens barrel. (Extremely important)

Then sit the NN T20 attached to the camera on top of the NN180 arm and using the threaded knob from the underside screw it into the NN T20.

Job done!

Now to find the NPP .....

Regards, Smooth
Alternate Text
Joined: 2009-08-30
Send Msg:
Posts: 64
2009-09-26
#6
ok, Smooth. I got it. Thank You
Regards, Sal