panorama software,virtual tour software
Alternate Text
Joined: 2009-08-30
Send Msg:
Posts: 64
2009-09-26
#1

Panoweaver Question

Hello:

Does anyone knows, why, sometimes I try to convert a single image (not stitching) from Sperical to Cubic, just using the "Spherical To Cubic" button. But sometimes when I open my image inside the panoweaver, the "Spherical To Cubic" button lights up, so I can convert it, 

But sometimes not, I dont know if the image size is the matter, I dont like to use Pano2vr, I like this one.

Does anyone knows why? or what I have to do , so Panoweavers "Spherical To Cubic" button always be on, when I import a single image.


Regards, Sal
Alternate Text
Forum Moderator
Joined: 2002-11-23
Send Msg:
Posts: 5438
2009-09-27
#2
It is not designed for a single image. Unless this image is a stitched panorama.

What are you trying to achieve?

Regards, Smooth
Alternate Text
Joined: 2009-08-30
Send Msg:
Posts: 64
2009-09-27
#3

i was just trying just to test, to convert a equirectangular from Ptgui to spherical.

I did it several times, with success.

Suddenly

an image that I tried to convert again, was not accepted into panoweaver, (and I noticed that the button was off)

 

thats why the question.

thank you


Regards, Sal