Does anyone know how to add the hovering hubcap logo to Tourweaver? It worked great with panoweaver, so one would assume there is a way to code into Tourweaver.
Any help would be great.
Hmmm I think panoweaver actually places the "Floor - Ceiling" caps directly into the image. As the panorama rotates so does the cap because its a fixed part in the bottom of the panorama.
PtViewer.jar applet code allows for a 'floating' or hovering cap as seen on some of our Fort Worth Architecture 3D city map page. This is done by placing a HOTSPOT "0" x, y location at the center bottom and displays a small premade cap. The premade cap is usually a transparent circle .gif file. This cap does not rotate with the picture, but rather it floats in a fixed position. We use it for advertising our client and our logo. If someone wants to tilt far down they can see it. Otherwise it stays out of sight.
I think I figured it out now.
The settings are a bit different than placing the code in the PTViewer script, but the same concept. Tourweaver allows you to place hotspots in each pano (as you already know). I simply needed to place the transparent gif over the tripod at the bottom of the pano and it will hover. Still trying to find the correct XY settings to keep the image from wobbling though.
Thanks for your help,
Tourweaver has simplified the hovering hubcap logo, but I have not got the XY positions yet (have not spent much time on that yet though).
I tried the XY positions I used with Panoweaver, they didnt match up the same in Tourweaver.
Basicly all you will need to do with Tourweaver is create your transparent gif image, place a hotspot into your pano (at the lower part of the pano to cover the tripod), change the image associated with that hotspot to your transparent gif image...That's it. After that maybe we both can work on getting the correct centered XY settings. It is programed to hover the image already.
Hope this helps a bit.
I actuallyknow how to create the tripod cap/hubcap.
I'm interested in how you make the cap "hover" vs. the rotate when you rotate the image. As far as I know, there's nothing in Tourweaver that does that for you.
Maybe I can help. We found that while using straight ptviewer.jar that the bottom floating tripod cap will be displayed if you provide the X and Y axsis. For most of mine the HOTSPOT is 488 pixels on the X axis and 488 pixels on the Y axsis.
The upper left corner of the panorama is considered the 0 or zero mark from which to measure. So its is 488 pixels from the left edge of the image and 488 pixels down from the top of the image.
It might be that in Tourweaver the 0 zero mark is measured from another location. Maybe 0 is center most in the image which is 50% from the left image side and 50% down from the image top?
OR from the top right or bottom right image side.
If you can get the hotspot image to display but in the wrong location I would think that if using trial X=0, Y=500 or the reverse x=500 and y =0 positions might help determine where the start measuring point is located.
Only a thought